Cisco-Linksys WET11 Wireless Ethernet Bridge Review

Cisco-Linksys WET11 Wireless Ethernet Bridge
Average Reviews:

(More customer reviews)
After reading the specs on the Linksys WET11 and downloading the user manual from their website, I decided to purchase a unit. I am very pleased with this product and it works as I had expected.
Setting it up was a breeze. The antenna is screwed on to the right side of the unit (which is surprisingly small). Plug in the power supply. I then hooked it up to a PC laptop with the supplied RJ45 cable and ran the setup program. I have an SMC Barricade 7004AWBR router with a built in wireless access point. The WET11 was configured to use the same SSID and channel as the SMC and then set to DHCP. All done.
The unit can then be connected to your ethernet device in one of two ways. One is directly to your desktop or laptop, for example. The other is to hook it up to a hub or switch and from there wire it up to one or more desktops or even laptops. There is a switch on the unit to select which mode will be used. While I do have a wireless card for the laptop, it's nice to have the flexibility of going wired for desktops.
The icing on the cake is that I now have wireless connectivity for my Mac Beige G3. I've been looking for a solution and the WET11 solves it. Before, I had to run a long RJ45 cable to it from the router. Now I can connect it to the WET11 through either of the two options mentioned and get on the web as before, except it's now wireless. One tip - set the Mac to a manual IP address. For some reason, setting the Mac for DHCP does not work. For me a very minor issue.
I have not seen any dropped connections for the few days I've had it and it sure runs cool. All in all, it has met my expectations, perhaps more so with the Mac. For the money, I see no comparable product out there. Check it out.

Click Here to see more reviews about: Cisco-Linksys WET11 Wireless Ethernet Bridge

The versatile wireless Ethernet bridge from Linksys can make any wired Ethernet-equipped device a part of your wireless network. At home, use the wireless Ethernet bridge to connect game consoles, set-top boxes, or computers to your wireless network to share your high-speed network connection. In the office, convert your Ethernet-wired printer, scanner, camera, notebook, or desktop into a wireless networked device.
It's completely driver-free, so it works on any platform and with any operating system. Because there are no drivers to load, setup is a snap--just plug it into your device and configure the network settings through your Web browser.
You can also use the Linksys wireless Ethernet bridge as a kind of "cableless cable" to connect remote areas together. Maybe the Shipping department is all the way across the warehouse from Receiving. Or maybe you want to set up a home office in your detached garage. With a wireless Ethernet bridge in the garage and an other one (or a wireless access point) in the house, you're connected--without the hassle of cabling.


Buy Now

Click here for more information about Cisco-Linksys WET11 Wireless Ethernet Bridge

0 comments:

Post a Comment